The Vantage Power Station is a large capacity dimmer and power booster. It is designed to handle larger than standard loads or to increase the power capacity of dimmer stations. Several models are available for high load commercial and residential applications.

Download spec sheet

Each station can handle up to 16 Amps with a standard load and 8 when dimming electronic loads. The high capacity heatsink comes with an attractive white cover. Other covers are available in almond, black, brown, and ivory.

Power Stations connect to the Vantage system in one of two ways. The first method is to connect the Power Station to a ScenePoint Dimmer station load output. In this configuration the dimmer station controls the dim level and the booster handles the power. Another option is to connect the Power Station directly to a Vantage Master through the station bus. It will then act as a high-power, single-station dimmer.

Key features:

• Connects directly to the station bus or to a ScenePoint Dimmer
• Handles up to 16 Amps for incandescent loads and 8 for electronic loads
• Expands the system capacity without adding modules or enclosures
• Counts as only one station towards the total allowed on a Vantage system
• Accepts programming as a dimmer or relay
• Communicates with the Vantage system on a two-wire bus
• Installs in a standard two-gang box
• Fits almost any décor with covers available in a variety of colors

CONTROLLERS
ENCLOSURES
MODULES
TOUCHSCREENS
SENSORS
SOFTWARE
DIN STATIONS

• BriteStyle Buttons
• HiddenToucH/KH11XG-KH11XB
• Keypad Station/KSXXXX
• Slave Keypad/SLAVE-1-SLAVE-2
• Station and Faceplate Finishes
• Strip Switch Keypad/STRIP-1-STRIP-2
• Contact Input Station/CIS
• 4 Channel Relay Station/STR4RW201
• Infrared Emitter Station/IRX
• Low Voltage Relay Station/LVRS
• Low Voltage Output Station/LVOS
• Power Station/STPSRW201-STPERW201
• RS-232 Station/Q-RS232S
• RS-485 Station/STC4RW001
• TheatrePoint/THEPT-I
• Communicating Thermostat/STAT
• Q-ETS3 Interface Station/Q-ETS3