The DIN Dimmer Station is used to incrementally expand the control and dimming capacity of the Vantage automation and lighting control system. It is designed to easily install on standard 35 mm DIN rail and has connections to control up to four 600 watt loads at 240 VAC. The Dimmer Station can communicate with a Vantage master through a two-wire bus or a small connector on its side to orchestrate complex and elegant lighting scenes. Each load can also be independently controlled from the four buttons on the front of the housing.

On the top of the DIN Dimmer Station are six contact inputs. The six inputs are dry-contacts which can be used to receive input from buttons, motion sensors, door contacts, stress sensors, and more. Connections five and six can also be used to connect a Vantage remote IR receiver and a Vantage LightPoint sensor respectively.

Key features:

• Controls the dimming for up to four 600 watt loads at 240 VAC or four 300 watt loads at 120 VAC
• Features six contact inputs for control of additional auxiliary devices
• Acts as an independent dimmer or coordinates with the Vantage system to create elegant lighting scenes
• Dims magnetic and electronic low voltage, neon, cold cathode and more
• Displays the operating status with LED indicators
• Clips easily on standard 35 mm DIN rails
• Executes single or multiple events from single trigger
• Communicates with the master through a two-wire bus or by a small connector on the side of the unit

CONTROLLERS
ENCLOSURES
MODULES
TOUCHSCREENS
SENSORS
SOFTWARE

• DIN Electronic Dimmer Station/DIN-EDS
• DIN 8 Channel Relay Station/STR8RW201
• DIN Contact Input Station/STIDEW101
• DIN Low Voltage Relay Station/STOLEW801
• DIN Dimmer Station/STDSEW240 discontinued