The DIN Contact Input Station provides a single integration point for a large variety of sensor inputs, relay-type outputs, and external switches from third-party systems. Each station features ten contact input channels for monitoring the open and close states from a variety of external devices. These devices include magnetic door contact switches, momentary switches, motion detectors, stress sensors, humidity and temperature sensors, smoke and carbon monoxide detectors, driveway probes, and much more. The last two connectors can also be used to receive input from Vantage's LightPoint sensor or an external IR receiver.

Contact Input Stations easily install on standard 35 mm DIN rails. The stations communicate with the master through a two-wire bus using either screw terminals or a small connector on the side of the unit. Each station can quickly become part of Vantage's powerful scene orchestration capabilities with the user friendly QLink
programming software.

Key features:

• Provides a single integration point for up to ten contact inputs
• Allows seamless integration with most passive infrared motion
  detectors, door contacts, stress sensors, light sensors, humidity and temperature sensors, smoke and carbon monoxide detectors, and more
• Clips easily on standard 35 mm DIN rails
• Accepts programming using a PC with Windows 98 or higher via Vantage's QLink software
• Communicates with the master through a two-wire bus or by a small connector on the side of the unit
• Offers a connection for one external IR receiver and a Vantage LightPoint sensor
• Installs directly on the Vantage station bus

CONTROLLERS
ENCLOSURES
MODULES
TOUCHSCREENS
SENSORS
SOFTWARE

• DIN Electronic Dimmer Station/DIN-EDS
• DIN 8 Channel Relay Station/STR8RW201
• DIN Contact Input Station/STIDEW101
• DIN Low Voltage Relay Station/STOLEW801
• DIN Dimmer Station/STDSEW240 discontinued